Making a Bow with Av Bros page curl

Open image 600 x 600
Using preset shape rectangle draw your ribbon
making sure it is center of you palette.

Duplicate the ribbon

Rename the first one bow.

Go to Effect..av bros..use settings below..(you can play around
and get desire effect for different lengths)




Erase the corner so you have a bow side.  Duplicate this image
and mirror.  Use deformation tool to angle the way you want.

 
Once you have it right go back to your orginal ribbon use
your selection tool (with magic want) and draw out a small square
over it..copy and paste new layer.  Now you should have small
square you can use a bow center.  Rename this layer bow center.

Move this between the two bow sides.  Using deformation tool..bring it
in and make fit between the two.  Use warp brush or mesh warp to bring
it around bow side to look real.

Go to original ribbon layer.  Duplicate.  On copy use av bros again, settings
below, but you can play with it to get what you want. I erase the top part
place it underneath my bow layer.

You can now either adjust the setting some for second ribbon  or even just duplicate the first one and mirror it.  I duplicated the ribbon in the beginning so it is easier to decide later on what to do, that way  I have a extra to
use.  Once it is done to your liking, delete any extra ribbon and merge visible
and save to your kit or work.

You can also use Tramage pool shadow at this point to get silkier look.